Atomik A.R.C. C1, Инструкция по эксплуатации

Страница: 17 / 20

17
BOAT MAINTENANCE
DRIVE LINE
1. Remove the propeller.
2. Loosen the motor coupler set screws for the flex cable.
3. Slide the flex cable out of the drives.
4. Lubricate the flex cable with marine grease.
5. Lubricate the drive ball bearings with a light oil for bearings.
6. Reassemble the drive and wipe away any excess grease and oil.
HULL
1. The hull requires very little maintenance, but must be kept in good condition in order to perform as expected and to
ensure safe operation.
2. Look closely at the exterior surfaces of the hull.
3. Check for damage, chips, cracks and scratches.
4. Determine if damage has weakened the fiberglass and take the appropriate action to fix the
damage. Scratches and hair line cracks are common and typically do not require any attention.
HARDWARE
1. Radio control boats experience high frequency vibrations and as a result the screws, nuts and bolts will become
loose.
2. Check all the motor hardware and motor mounts.
3. Check all running gear, hardware, rudder, drive, steering linkages, hatch quick releases, water-cooling
system, etc.
4. Use thread lock on all metal to metal hardware contacts.
WHAT TO DO AFTER THE BOAT HAS BEEN SUBMERGED
1. Remove the motor and lubricate the bearings on the motor.
2. Remove the electronics.
3. Dry out the interior.
4. The servo, receiver and battery packs will need to be dried out and checked for proper
operation before they are used again.
5. Test the battery pack under load to make sure it is ok to continue regular use.
PARTS LIST
1876 TeflonTube for FlexShaft - King/Segad
1878 5 x 10 Ball Bearing - King/Segad
1883 Rubber Push Rod Seals - King/Segad
1887 Drive Dog - King/Segad
1890 Control Linkage - King/Segad
1891 Water Pickup - King/Segad
1897 Flex Shaft - King/Segad
1898 Scale Rudder Assembly - King/Segad
1907 Strut Assembly - King/Segad
1913 CNC Aluminum Hatch Lock Set
1999 Motor Coupler For 6mm Shaft - EC1
8186 VR3S 3-Channel 2.4GHz Tx/Rx
8188 2.4GHz 3-Channel Micro Receiver
1368 V700 Marine Outrunner - 1100Kv
1396 Pro Brushless Marine 120AMP ESC
15021 25C 6S 5000mAh 22.2V LiPO
15048 50C 6S 5000mAh 22.2V LiPO
1694 EC5 Connector Female - Battery
1695 EC5 Connector Male - Device
1696 EC5 Charge Lead 18”
1792 Hull/Hatch Set - EC1
1793 Propeller 54mm for 58” Electric C1
1794 Motor Mount for 58” Electric C1
1795 Hatch - EC1
1825 High Torque Metal Gear Servo
1885 Alloy Antenna Holder - King/Seg/EKO
1886 Antenna Tube - King/Seg/EKO
Motor Coupler Set Screw Motor Coupler Set Screw
Use high quality Marine
Grease to lubricate the
flex cable.