Operation and Maintenance Manual - EN
EN
www.atmos.cz
EN-9
Connecting the compressed air system
INFO
– turn the solenoid with screw to a tight position so the tube isn’t twisted and
everything the set-up looks good, taking account of the position of the compressor in the
boiler room.
WARNING
– the compressor and tube should be located
sufficiently far from any heat
sources
to ensure they are not damaged.
Installing the burner and connecting it to the boiler
Connect the connecting cable with a 6-pin co-
nnector on both ends between the burner and
boiler
Affix the pellet burner to the appropriate boiler
and fully tighten
Take the other end of the connecting tube with
the seal and carefully connect it to the complete
screw fitting with solenoid
Take the connecting tube, screw it to the compre-
ssor and tighten fully
