12
Scope of delivery
• 1 × Device
• 1 × Main power connection cord (C13 to wall plug)
• 1 × Quick Start Guide
Consumables
• 2 × G4 Dust collector for air inlet (pre-installed)
• 4 × G4 Dust collector for air inlet (replacement)
1 ×
2 ×
4 ×
1 ×
1 ×
Scope of delivery
Consumables
ATMOFIZER PRO – USER MANUAL – 7. INSTALLATION / SET-UP
QUICK
START GUIDE
When positioning the device, observe the minimum distance from
walls or other objects as described in the chapter Technical data.
• The device may only be used in environments with no
excessive formation of dust.
• Set the device up in an upright and stable position.
• Position the device on even and stable and ground in to
prevent it from tipping over.
• When setting up the device, ensure a sufficient distance for air inlet
and outlet as well as for operation (see Technical data).
• Make sure that extension cables are completely unrolled.
• When positioning the device, keep a sufficient distance to
heat and moisture sources.
• Make sure that no curtains or other objects interfere with the air flow.
• Fasten all brakes (mind your fingers and/or toes).
• Do not create tripping hazards when laying the power cable or other
electric cables, especially when positioning the device in the middle
of the room. Use cable bridges.
For long-lasting installation in one place, put the caster brakes on firmly.
Attach a tilt-protection to the appliance as reasonable. Consider mounting
/ fixing the device to the floor and/or wall (do not cover the side inlets).
Supply cables must be laid in cable ducts and removed from escape routes.
Connecting the power cable
• Insert the mains plug into a properly secured mains power socket.
• Before (re-) starting the device, check the condition of the power
cable. If there are doubts as to the mint condition, contact the
customer service.
Positioning the device
min.
30 cm
19.7 in
min.
50 cm
11.8 in
Only place on hard surfaces
and do not cover device
Connecting the power cable
