Atmel I/O1 Xplained Pro, Руководство пользователя

Страница: 11 / 16

the full SD card specification, see sdcard.org . The connections to the microSD card connector are shown
in the table below.
Table 4-9 microSD Connector Connections
Pin on EXT
connector Pin name microSD
card
connector
pin Comment
- D2 1 Data line 2 on microSD card
15 D3 2 Data line 3 on microSD card. Active low chip select pin for
microSD card, pulled high through 100kΩ pullup resistor.
16 CMD 3 Command line for microSD card. Connected to SPI_MOSI.
VCC VDD 4
18 CLK 5 Clock line on microSD card. Connected to SPI_SCK.
GND GND 6
17 D0 7 Data line 0 on microSD card. Connected to SPI_MISO.
- D1 8 Data line 1 on microSD card
10 SW_A 9 When a microSD card is put into the connector, SW_A and
SW_B are short-circuited. SW_A is connected to the
microSD_DETECT signal. To use this as a card indicator
remember to enable internal pullup in the target device.
GND SW_B 10
4.3.5. Light Sensor
I/O1 Xplained Pro features a TEMT6000 light sensor from Vishay. The sensor data can be read by an
ADC pin on n Xplained Pro MCU board.
Table 4-10 Light Sensor Connections
Pin on EXT connector Function
3 Light sensor signal
Atmel I/O1 Xplained Pro [USER GUIDE]
Atmel-42078B-IO1-Xplained-Pro_User Guide-10/2015
11