– Getting Started Guide USER GUIDE
Atmel-42517C-ATBTLC1000-BluSDK-Proximity-Reporter-Getting-Started-Guide_USERGUIDE_022016
1
1
11
5
On-board LED Configuration
The on-board LED in
is configured to notify the user about the alerts received. This
section provides the default configuration of on-board LED for the Link Loss and Immediate Alert
service.
5.1
Link Loss
On link loss the LED will blink according to the alert level set by the Proximity Monitor.
The Alert Levels are:
1.
‘0’ for “No Alert”
2.
‘1’ for “Mild Alert”
3.
‘2’ for “High Alert”
The rate of LED blinking depends on the alert level configured by the Proximity Monitor. If the link loss
alert level is
‘High Alert’ then LED blinking rate will be fast (1 second interval) and if it is ‘Mild Alert’ then
the blink rate is moderate (2 second interval) and for
‘No Alert’ the LED is turned off.
5.2
Alert on Path Loss (Immediate Alert)
This alert is applicable when ‘Immediate Alert Service’ is implemented. The example application relies
on path loss configuration done by the Proximity Monitor and will notify accordingly.
The Alert Levels are:
1.
‘0’ for “No Alert”.
2.
‘1’ for “Mild Alert”.
3.
‘2’ for “High Alert”.
The rate of LED blinking depends on the alert level sent by the Proximity Monitor. If the link loss alert
level is
‘High Alert’ then LED blinking rate is configured for 3-second interval and if it is ‘Mild Alert’ then
it is configured for 5-second interval and for
‘No Alert’ the LED is turned off.
B
