Atlas Copco XRHS 1150 CD4 C3 WUX, Инструкция по эксплуатации

Страница: 65 / 106

- 65 -
OIL SPECIFICATIONS
High-quality, mineral, hydraulic or synthesized
hydrocarbon oil with rust and oxidation inhibitors
anti-foam and anti-wear properties is recommended.
It is strongly recommended to use Atlas
Copco branded lubrication oils for both
compressor and engine.
Only use synthetic compressor oil.
Never mix synthetic with mineral oil.
Remark:
When changing from mineral to
synthetic oil (or the other way around),
you will need to do an extra rinse:
After doing the complete change
procedure to synthetic oil, run the unit
for a few minutes to allow good and
complete circulation of the synthetic oil.
Then drain the synthetic oil again and
fill again with new synthetic oil. To set
correct oil levels, proceed as in normal
instruction.
COMPRESSOR OIL
Synthetic compressor oil PAROIL S
Synthetic compressor oil PAROIL S xtreme
Liter US gal Order number
can 5 1.3 1630 0160 00
can 20 5.3 1630 0161 00
barrel 210 55.2 1630 0162 00
container 1000 264 1630 0163 00
Liter US gal Order number
can 20 5.3 1630 0180 00
barrel 210 55.2 1630 0181 00
container 1000 264 1630 0182 00
The viscosity grade should correspond to the ambient temperature and ISO 3448, as follows:
Type of lubricant Compressor Engine
between -25°C (-13°F) and -10°C (14°F) PAROIL S
between -10°C (14°F) and +30°C (86°F) PAROIL S PAROIL E
b30°C (86°F) and +50°C (122°F) PAROIL S xtreme PAROIL E