Atlas Copco SMARTROC D65 TIER 4 FINAL, Руководство по обслуживанию

Страница: 23 / 220

SmartROC D65 Tier 4 Final 2 General
23
2.
First connect the positive terminal of the auxiliary battery to the positive terminal of the
chassis battery (2).
3.
Then connect the negative terminal of the auxiliary battery (1) to ground on the
chassis (not to the chassis battery's negative terminal).
4.
Once the engine has started, first remove the starter cable between the chassis and
the negative terminal on the auxiliary battery (1).
5.
Then remove the cable between the positive terminals of the batteries.
2.3 Steel ropes
2.3.1 Scrapping guidelines for steel cables
Steel cables should be scrapped when they display any of the following:
n
Wire break at attachment
n
Occurrence of strand breaks
n
Concentrations of wire breaks
n
Effects of heat
n
Occurrence of wire breaks due to operating time.
n
Reduced elasticity
n
Decreased cable diameter
n
Certain number and type of wire breaks
n
Corrosion
n
Surface wear
n
Deformation of the cable
n
Permanent extension of the cable
Wire break at cable mounting
Broken wires at cable ends indicate that they have been heavily loaded and can be caused
by faulty end mountings.
Shorten the cable and reattach it. Check that the remaining cable is sufficiently long.
Occurrence of strand breaks
If there are strand breaks, the cable must be scrapped.
Concentrations of wire breaks
If there are concentrations of cable breaks, the cable must be scrapped.
If such concentrations occur within a length less than 60 cm or on an individual strand, the
cable must be scrapped.
If this is the case, the cable must be scrapped even if the number of wire breaks is less
than the maximum specified in the table.
Effects of heat
Cables exposed to extreme heat must be scrapped. The effects of heat can be established
through annealing colour.