Atlas Copco SMARTROC D65 TIER 4 FINAL, Руководство по обслуживанию

Страница: 16 / 220

SmartROC D65 Tier 4 Final 2 General
16
2.1.4 Signs for outsourced components
Signs are placed on the larger components of the drill rig. When ordering spare parts or
making enquiries in regard to the drill rig, the type designation and serial number must al-
ways be stated. Type designations and serial numbers are specified in a separate docu-
ment, MI (Machine Identification). Spare parts can always be ordered through Atlas Copco.
2.1.5 Dismantling and assembly
CAUTION
Risk of injury
Exercise extreme caution when slinging and hoisting heavy objects
u
Can cause personal injury
u
Hoisting must take place at the centre of gravity
u Only use slings which are intact and designed for the load they shall carry
u Fasten the straps to lifting eyes, when available
Before transporting in shafts or the like it may be necessary to fully or partially dismantle
the drill rig. Observe the following when dismantling, hoisting and assembling:
n
Before dismantling, hose the entire rig clean with water and/or detergent containing a
grease solvent.
n
Observe the strictest cleanliness when dismantling hydraulic, compressed air and wa-
ter flushing hoses. Immediately plug all hoses, nipples and hydraulic oil pipes, or seal
and protect them from dirt in some other suitable way.
n
Mark hoses, pipes and other connections, where this has not already been done, to
make reassembly easier and prevent mix-ups.
n
Use properly secured lifting tackle of generous dimensions.
!
NOTE: When the drill rig is scrapped, all materials that are harmful to the environment
must be disposed of in a manner prescribed by the authorities.
2.1.6 Long-term storage
The following points must be observed for long-term storage of the drill rig. In the event of
special conditions e.g. a dusty or corrosive environment, additional measures may be ne-
cessary.
n
The rig must have protection from rain, snow and strong sunshine.
n
Untreated steel surfaces must be rustproofed.
n
The water mist system must be drained and rinsed with antifreeze.
n
The battery must be disconnected. If the temperature falls below freezing point then
the battery must be stored indoors.
n
The rock drill's shank adapter must be greased.
n
The rock drill's gas accumulator must be drained.
n
If the rig is to be shutdown for a long time then the rock should drill should be removed
and stored protected.
n
Fuel and oil tanks must be filled.