Atlas Copco GA 11+, Инструкция

Страница: 111 / 152

8 Maintenance
8.1 Preventive maintenance schedule
Control panel
Warning
Before carrying out any maintenance, repair work or adjustments, proceed as
follows:
• Stop the compressor.
• Close the air outlet valve and open the condensate drain valve to depressurize the
air system between air receiver and outlet valve.
• Press the emergency stop button (10).
• Switch off the voltage.
• Depressurize the compressor.
For detailed instructions, see section Problem solving .
The operator must apply all relevant Safety precautions .
Warranty - Product Liability
Use only authorised parts. Any damage or malfunction caused by the use of unauthorized parts
is not covered by Warranty or Product Liability.
Service kits
For overhauling or carrying out preventive maintenance, service kits are available (see section
Service kits ).
Service agreements
Contact Atlas Copco to set up a tailor-made service agreement. It will ensure optimum
operational efficiency, minimize downtime and reduce the total life cycle cost.
General
When servicing, replace all removed O-rings and washers.
Intervals
The local Atlas Copco Customer Center may overrule the maintenance schedule, especially the
service intervals, depending on the environmental and working conditions of the compressor.
The longer interval checks must also include the shorter interval checks.
Service plans for compressors with an Elektronikon
TM
Touch controller
Besides the daily and 3-monthly checks, preventive maintenance actions are specified in the
schedule below.
Each plan has a programmed time interval at which all service actions belonging to that plan are
to be carried out. When reaching the interval, a message will appear on the screen indicating
Instruction book
2920 7118 31 109