21
2.2
Connecting the Switch
1.
Since the switch does not include a power switch, plugging its power
adapter into a power outlet will immediately power it on.
With the Auto-MDI function, you just need to plug-in the
network cable to the hub directly and no need to care if the
end node is NIC (Network Interface Card) or switches and
hubs.
2.
A PC can be connected to the Switch via a two-pair Category 3, 4, 5
UTP/STP cables. The PC (equipped with a RJ-45 10/100Mbps phone
jack) should be connected to any port of the Switch.
The LED indicators for PC connection dependent on the LAN
card capabilities. If LED indicators are not light after making a
proper connection, check the PC LAN card, the cable, the
Switch conditions and connections.
3.
After plugging the selected cable to a specific port, the system uses
auto-negotiation to determine the transmission mode for any new
twisted-pair connection: If the attached device does not support auto-
negotiation or has auto-negotiation disabled, an auto-sensing process is
initiated to select the speed and set the duplex mode to half-duplex.
Содержание NetMaster F5P
Страница 1: ......
Страница 33: ...Atlantis SpA Via S Antonio 8 10 20020 Lainate MI info atlantis land com...