Atlantic Aeromobile 3000W, Инструкция по использованию и установке

Страница: 1 / 2

ATLANTIC Mobile Fan Heaters
User and installation instructions
Use
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities,or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The electric fan heater is intended for space heating in various premises. It is movable, but can also be
permanently installed.
The electric fan heater is approved for use in humid and wet areas, and is employed on building sites, in stores
and shops, and in the home. The fan heater has been subjected to electrical safety testing.
The fan heater is CE marked. Degree of protection: IP 44
Safety
• Don’t use this heater in the immediate vicinity of a shower, bath or swimming pool.
• Don’t cover the heater since it could then overheat and could cause a fire.
• Some of the heater surfaces become hot when the heater is in operation.
• Locate the heater so that any combustible material will not be ignited.
• Don’t locate the heater immediately below a permanent wall-mounted power outlet.
• If permanently installed in a bathroom or shower room, make sure that the heater is
installed so that the person using the bath or shower will not be able to touch it.
.
The heater must be stable when installed to avoid any risk of falling or overheating.
. Always keep 2.5m distance between the frontgrill and any object or hindrance
Operation
Thermostatically controlled fan motor
The fan motor will stop when the thermostat has switched off the heater.
1. Fan
2. Fan + 1/2 output
3. Fan + 1/1 output
Continuous operation
The fan motor runs continuously regardless of the thermostat setting.
4. Fan
5. Fan + 1/2 output
6. Fan + 1/1 output
Thermostat, 0
– 35°C
Cleaning
Clean the heater at regular intervals, since dust and dirt may cause overheating and give rise to the risk of fire.
Service and repairs
The following work should be done by personnel from the manufacturer or a service company, or by equivalent
qualified personnel:
Changing the power supply cable.
The heater has a built-in temperature limiter that will trip the power supply in the event of overheating.
If the temperature limiter has tripped, isolate the power supply to the heater, allow the heater to cool down and
attend to the fault.