Atlantic 522911, Руководство пользователя

Страница: 8 / 32

- 8 -
3 2 Commissioning the appliance
• The installation and first commissioning of the heat
pump must be performed by a qualified installer. This
person will also instruct you on how to start and run
the heat pump
• Ensure that the installation is correctly filled with water
and properly drained and that the pressure measured
by the pressure gauge is sufficient (1 to 1.5 bar).
• Close the installation's main circuit breakers
In winter, or after long shutdown periods, close the
installation's main circuit breakers (power supply
to the outdoor unit) a few hours before activating
the heating demand to allow the compressor to
pre-heat
3 3 Commissioning
WITHOUT room thermostat
Once your installer has commissioned your installation:
• Set the current date and time (see §
3.3.2 )
• Select the programming mode for heating (and for
cooling if your installation is equipped with the cooling
kit) (see § 3.3.3, page 10 )
• Set the temperature setpoints where necessary (see §
3.3.4, page 12 )
• Select the DHW programming mode (if the installation
is equipped with a domestic hot water tank and
electrical back-up) (see § 3.4, page 14 )
3 3 1 Basic display
The basic display on the user interface informs the user
of the main activity of the HP in progress
figure 3 - Loria 6000
1 User interface (Operator section)
2 Pressure gauge (installation hydraulic pressure)
2
1
OK
figure 4 - User interface (example of basic display)
MODE programming
activated
Compressor on
Temperature setpoint for
comfort phase
Comfort phase of PROG
mode
View information for the
icon displayed ( heating
Area 1 )
User manual 1634 - EN
Loria 6000 heat pump