Atlanta Attachment Company 3200PB1, Техническое руководство и перечень запасных частей

Страница: 21 / 48

Technical Manual & Parts Lists
16
Motor Parameter Settings
(3300A-PrePAR)
Before Programming, Perform a Master Reset of Parameters (See Below)
PARAMETER RANGE VALUE DESCRIPTION
290 0
Mode of operation. MUST SET THIS PARAMETER
FIRST!
026 0
111 0-999 0900 Maximum speed when "129" is 0, 1, or 2.
119 1-3 1 Linear acceleration
153 0-50 0 Braking power at standstill
161 0-1 1-CCW Motor rotation
207 1-55 1 Braking
220 1-55 1 Acceleration
240 0-56 55 Enable reverse run of motor with input 1
270 0-5 5 No handwheel sensor
272 020-255 1000
Drive ratio between motor pulley and handwheel pulley. If
handwheel pulley is smaller than motor pulley, increase
this value to slow down sewing head until measured
speed matches speed set with parameter 111.
436 0
401 1
Front panel LED's: Programming Instructions:
LED 1: Off
1. Power on holding down the "P" button till "CODE" is
displayed.
LED 2: Off 2. Press ">>" once and enter the number "5913"
LED 3: Off
3. Press "E" once and "4.0.0." is displayed this is a
parameter
LED 4: Off
4. Proceed to the parameter to be changed and press
"E"
LED 5: Off
5. The value now shows in the screen, adjust to desired
value.
LED 6: Off
6. Press "E" to enter value and continue with parameter
setting.
LED 7: Off, Stop at needle down.
7. Repeat for other parameters, press "P" once when
complete.
LED 8: Off
8. Run sewing head to save parameters before powering
down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "CODE" is
displayed.
2. Press ">>" once and enter the number "5913"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default
values.
Speed RPM Treadle/Low
Fast 163 C
Slow 135 A, C