Quick-Change
Installation and Operation Manual
Document #9620-20-H-UAx-13
Pinnacle Park
•
1031 Goodworth Drive
•
Apex, NC 27539
•
Tel: 919.772.0115
•
Fax: 919.772.8259
•
www.ati-ia.com
•
Email: [email protected]
H - 9
4.4 Electrical module Pin Block Inspection and Cleaning
Inspect the Master and Tool pin blocks for any debris or darkened pins.
Figure 4.1—Inspect Master and Tool Pin Blocks
If debris or darkened pins exist, remove debris using a vacuum, and clean using a nylon brush (ATI part
number 3690-0000064-60).
Inspect the Master and Tool pin blocks for stuck pins or severe pin block damage.
Figure 4.2—Stuck Pin and Pin Block Damage
If stuck pins or severe pin block damage exists, contact ATI for possible pin replacement procedures or
module replacement.
4.5 Electrical Module Seal Replacement
Replace the V-Ring seal:
To remove the existing seal, pinch edge of seal with fingers and gently pull the seal away from the pin
block on the Master.
Pull the seal off the pin block.
NOTICE:
Do not use an abrasive media, cleaners, or solvents to clean the contact pins.
Using abrasive media, cleaners, or solvents will cause erosion to the contact surface.
Clean contact surfaces with a vacuum or non-abrasive media such as a nylon brush
(ATI part number 3690-0000064-60).