INSTRUCTIONS FOR THE USER
210-0197_Libretto_TX_ATI_2020-02_ATI-eng
16
ed. 2020-02
21 RECOMMENDATIONS FOR YOU
•
Keep this booklet for future reference. The booklet should be kept near the stove.
•
For free verify the correct installation of the device, the end user can directly contact one of the closest authorized
service centers.
•
All the steps in the space reserved for the installation and maintenance must be performed by qualified and
authorized according to existing regulations. An incorrect installation, caused by not observing the instructions
provided by the manufacturer, may cause damage to people, animals or things, for which the manufacturer
assumes no responsibility.
•
The device has been built for the production of hot water: any other type of use is to be considered as dangerous
and unsuitable.
•
The appliance does not go outdoors installed in damp environments, to be protected from splashes, jets of water or
other liquids, to avoid anomalies to electrical and thermal devices.
•
The installation must be performed by professionally qualified personnel responsible for complying with current
safety standards.
•
Any packaging components (plastic bags, polystyrene, wood, staples, etc.) Must not be left within reach of children
as they are potential sources of danger.
•
Carefully read the instructions and warnings contained in this booklet as they provide important information about
safety, use and maintenance.
•
In case the appliance is sold or transferred to another owner, ensure that this booklet accompanies the same, so
that they can be consulted by the new owner and / or installer.
•
Do not place any kind on the subject.
•
To get the best result and the warranty terms, we recommend that you follow the operating instructions below, to
make regularly the unit checked by qualified personnel and only use original spare parts and kits supplied by the
manufacturer.
•
It 'not tamper with any device calibrated and sealed at the factory by the manufacturer.
22 IGNITION AND TEMPERATURE CONTROL
1)
switch
2)
regulating thermostat
3)
manual reset safety thermostat (water safety)
4)
thermometer
5)
bright green light operation
6)
reset button and lock indicator
7)
manual reset safety thermostat (flue safety)
a) Press the switch
1
to "I"
b) Check that the red light button lock
6
is off. If it is on, this means that the control apparatus is located in a state
of "block". In this case push the same button to unlock the control apparatus. The button's light goes out
c) Bring the index of the regulating thermostat
2
on the desired water temperature value. From this moment starts
the ignition cycle of the generator: are controlled the opening of the gas valve and simultaneously the action of
the electrode for the spark ignition of the burner.
d) During the ignition of the burner the flame must be detected from the special ionization probe within the safety
time (10 sec), otherwise the control apparatus goes into a locked state. This is reported ignition button of the
red light
6
. This can easily happen in a new plant, where it can still be present air in the gas pipe. In this case,
