Athena 1090 EVO, Перевод оригинальной инструкции, Страница: 32 / 182

32
2.8 Safety indications on the use of the travel function
The instructions given below must be followed.
•
Make sure movements are done on flat, sturdy ground. To do this, use the
spirit level located on the work platform.
•
Make sure that there are no hollows or ridges in the floor and that there is
enough room for the machine to pass through.
•
Make sure that there are no bystanders or obstructions in the surrounding
area before moving off
•
Do not CHANGE DIRECTION on kerbs, rocks or appreciable differences in level
(> 10 cm) when driving the machine. In this case, always proceed
perpendicularly to the obstacles.
•
If you must drive up a slope, do not change direction when the ground
changes from flat to sloping. If this is absolutely necessary, perform the
manoeuvre gradually.
•
Do not drive along the edge of slopes or over uneven ground with one track
horizontal and the other slanting or partially raised (>10°) as this will
damage the tracks. ALWAYS PROCEED WITH THE TRACK SHOES RESTING ON
THE SAME HORIZONTAL PLANE.
•
Driving over an obstacle creates a gap between the bearing rollers and track,
which could consequently slip out of its housing.