Athena 1090 EVO, Перевод оригинальной инструкции, Страница: 157 / 182

157
WARNING: BE CAREFUL WHEN THE TRACK FALLS TO THE GROUND
8- Lift the track at the lower centre line
9- Pull the track out , prying between the track itself and the idler wheel
10- To install the new track, proceed as indicated in the previous points, but
in reverse order
11- The track is correctly tensioned by using the tensioning kit, pumping
grease until the pressure indicated on the technical data sheet has been
reached.
WARNING: before performing the tensioning of the track, check the technical
data sheet for the correct pressure expressed in bar.
6.2.24 Track reduction gear oil level inspection
Check the level of the oil in the track reduction gears at the frequencies given
in the general chart. Comply with the procedure described below.
This model features dual displacement gear motors with gears in oil bath.
It is very important to periodically check the oil level (frequency indicated in
the scheduled maintenance and checks table).
1- Move until the gear motor is in the condition in which the "FILL" cap is at
the top, and perpendicular to the "DRAIN" cap.
2- To drain the oil:
a. Unscrew the FILL cap
b. Unscrew the LEVEL cap
c. Unscrew the DRAIN cap