® Copyright ATH-Heinl GmbH & Co. KG, 2012, All rights reserved. / Misprints and technical changes reserved / Stand: 10/2013
28
Utilization
This product is designed for lifting vehicles. The relevant technical specifications of the lift have to be considered.
1. Preparation
a.
READ AND UNDERSTAND
all safety warning procedures before operating lift.
b. Lower the lift completely until the arm restraints device is deactivated.
c. Place the lifting arms parallel to the drive direction.
d. Drive the vehicle between the columns, paying attention by the load distribution.
e. Adjust swing arms so that the vehicle is positioned with the center of gravity midway between pads.
Adjust by turning up the height of the lifting pads until they will reach the manufacture indicated lifting
points, if necessary use the needed lifting adaptors.
Maximum height. 250mm or maximum one pad adaptors.
2. Lifting the vehicle
a. Switch on the main switch of the lift
b. Raise
the vehicle by pressing of the push button „UP“ until the vehicle is lifts of on a height of 100-
150mm.
c. Recheck to make sure the vehicle is secure and all locking pins are lock in place.
d. Always ensure safeties are engaged before any attempt is made to work on or near vehicle.
