Atest Gaz LTT2, Руководство пользователя

Страница: 13 / 32

www.atestgaz.pl
7.2 Configuration
Configuration of the signaller with Modbus interface is done by using dedicated
software (Sigma Toolbox).
This software can be downloaded from the manufacturer's website
https://www.atestgaz.pl/en/product/sigma-toolbox
A computer with installed software should be connected to the SBUS port of the
device (see Table 2). The device will be visible at address 1.
Possible parameters to be set: device address on the ExBus port, type of communication protocol and data
transmission parameters (see also Table 8).
8 Lifetime cycle
8.1 Transportation
The device can be shipped in the same way as new equipment of that type. If the original package or
another protecting means (e.g. corks) is unavailable the conveyed equipment must be secured against
shocks, vibrations or moisture by means of adequate methods and material at the own responsibility of the
sender.
The device can be conveyed under environmental conditions as described in Table 8.
8.2 Installation
All cable glands must be reliably tightened after installation.
The device must be installed in the working position as specified by the equipment
manufacturer.
The device must be installed at locations with low probability of its mechanical damage.
The device must be installed at locations with no exposure to UV radiation (e.g. no exposure
to direct sunlight).
Combining two or more wires at a single terminal is not allowed if such wires are not
clamped in a common cable lug.
s. 13|23
User Manual: POD-037-ENG R06