ATEN VM5404H, Руководство пользователя

Страница: 47 / 127

Chapter 3. Front Panel Configuration
35
IR Remote Control Operation
The IR remote control ( IR Remote Control , page 9) included with the
VM5404H / VM5808H can be used to:
 change the Input source of any Output display

power on/off individual Output displays; or
 power on/off all Output displays simultaneously
Before using the remote control, a user must first plug the IR External Receiver
into the rear panel of the VM5404H / VM5808H and place the receiver where
the IR signal can be reached (see
IR port , page 8).
Change the Input source of an Output display
To change the Input source of an Output display, using the remote control, do
the following:
1. Press the Output port number ( 1–8 ) or ( 1-4 ) you want to change.
2. Within 2 seconds press the Input port number ( 1–8 ) or ( 1-4 ) you want the
Output port to display.*
3. Repeat steps 1-2 to change additional ports.
*For the change to occur the Input number must be pressed within 2
seconds of pressing the Output number.
Power on/off individual Output displays
To power on/off individual Output displays, using the remote control, do the
following:
1. Press the Output port number ( 1–8 ) or ( 1-4 ) you want to power on/off.
2. Within 2 seconds press the ON or OFF pushbutton.*
3. Repeat steps 1-2 to change the power status back on/off.
*If the ON or OFF pushbutton is pressed after 2 seconds of pressing the
Output port number, all the displays are powered on or off instead of just
the intended Output port.