ATEN VK1100, Руководство пользователя

Страница: 97 / 176

Chapter 5. ATEN Configurator (VK6000)
87
Below lists Advanced Options that provide features to add conditions
to button commands. For more information on these options, see
Advanced Options , page 90.
Set Flag – sets a flag value to represent the new device status when a
command changes a device setting. Set Flags are added to the
Commands list after device commands to change the Flag (device
status).
Condition – adds a condition that must be met for commands to
initiate. A condition's set value must be equal to a Flag or Feedback
value for the command(s) below it to initiate. Conditions are added
before commands in the Commands list.
Change Button State – this command changes the image of another
button when this button is pressed – allowing the image of any other
button to change when the command from this button is sent. Change
Button State is added to the end of the Commands lists. When adding
this to a
Toggle button it allows the image to switch with the toggle
behavior: Normal or Pressed . In this situation the Change Button
State is added to the end of both the Toggle ON and Toggle OFF
Commands lists.
Change Label – this option changes a label’s text with text that you
enter manually or with text from a device’s return message. A
Manual Change Label can be added to the beginning or end and with
a Condition in the Commands list. Adding it to a Condition
guarantees the label only changes when the command initiates.
Change Group Button State – this option adds a command that
changes the button selected in a Radio Group (page 56). Create a
Radio Group and then a Function will be listed for it when Change
Group Button State is selected. Add the Change Group Button State
to the Commands list of a button and use the drop-down menu to
select the button in the Radio Group you want selected.
Change Slider Bar Level – this option adds a command that
changes the level of a Slider Bar (page 80). Create a Slider Bar and
then a Function will be listed for it when Change Slider Bar Level is
selected. Add the Change Slider Bar Level to the Commands list of a
button and use the drop-down menus to select the Slider Bar and
Level to change.
Š
Function – lists the commands that can be added to the Commands list.
Select an option under Device , then double-click or drag & drop
commands from the Function list to add them to the Commands list.