Chapter 3 Basic Operation
12
LED Display Notes
a) If the link has not been established after 80 seconds, it is likely the
connection was lost or the transmitter is out of range. You may have to
verify the range and adjust or shorten the distance between the
transmitter and receiver.
b) If there is no video being displayed and the “Format not supported”
icon appears, it is an indication that the video frame rate from the
computer is not supported. If this is the case, refer to page 26 to switch
to a supported video timing setting.
c) If you have more than one transmitter paired to the receiver, all devices
need to be at least 6.5 feet away from one another. If the transmitter and
the receiver exist in the same room, the suggested distance between the
two is a minimum of 6.5 feet.
Powering Off and Restarting
If it becomes necessary to power off the unit, before starting it back up you
must do the following:
1. Safely disconnect device from the source. Then proceed to remove the
transmitter from the source.
2. Shut down all devices that are connected to the VE819R.
3. Unplug the power cable and wait 10 seconds, then restart the receiver and
reconnect the devices.
4. After the VE819T / VE819R is up, power on the connected devices.
