2. Hardware Setup
8
VE809R - Receiver Installation
1. Place the VE809R Receiver up to 30m from the VE809T Transmitter.
2. Use the HDMI cable included with this package to connect the HDMI
video display (HDTV) to the HDMI output port on the rear of the VE809R
Receiver.
3. Plug the provided Mini USB Power Adapter into an appropriate power
source; plug the power adapter cable into the USB port on the VE809R.
IR Blaster Installation
The IR Blaster cable allows you to use a source device’s remote control from
the receiver side of the installation. To install the IR Blaster, do the following:
1. Plug the IR Blaster cable into the IR Out port on the rear of the transmitter.
2. Place the IR Blaster’s sensors on or near the source device(s) front panel
IR sensor port(s) (refer to the devices user manual for the exact location),
so that it can communicate with the IR signal, as shown in red below.
(Continues on next page.)
2
3
