ATEN VE157, Руководство пользователя

Страница: 16 / 49

VE157 / VE607 / VE807 User Manual
8
How to Supply Power
One pair of Power Adapter and Terminal Block Connector is provided in this
package, and can be used on either the Transmitter or Receiver side. The
second Cat 5e cable connection transmits the power signal.
Note: To supply power to each unit separately, you must purchase another set
of power adapter (within a voltage range of +9V~12V) and terminal
block connector. In this case, there is no need to connect the second Cat
5e cable.
The provided Power Adapter and Terminal Block Connector must be
combined. You can then use the modified power adapter to connect – first, to
the terminal block on either the VE157T / VE607T / VE807T or VE157R /
VE607R / VE807R rear panel; and then, to a power outlet to supply power to
your VE157 / VE607 / VE807. Follow the steps described below:
1. Cut off the connector end of the
power adapter.
2. Strip 5mm (0.5 cm) off the
insulation cover of the Power
Adapter cable to expose two wires:
a
+9V wire and a GND
(grounding) wire.
3. Insert the exposed +9V wire and
GND wire tightly into the provided
2-pin Terminal Block Connector.
The connector is properly labeled –
the
+9V and GND wires should be
plugged into the correct holes.
(Continues on next page.)
The exposed wires must constantly be separated
from each other to prevent any unexpected
damage (including short-circuits, electric shocks,
and so on.)
(+)
(-)
Connector
Provided