VM0202H / VM0202HB User Manual
14
6. (Optional) To switch sources using IR remote control, connect the
supplied IR receiver to the IR Receiver Port.
7. (Optional) To perform system control using a serial device via RS-232,
follow the steps below.
a) Connect the serial controller to the RS-232 Serial Port on the
VM0202HB using a 9-wire straight cable, with only pin 2 to pin 2, pin
3 to pin 3, and pin 5 to pin 5 connected.
b) Configure the serial controller’s control port to the following:
8. Plug the power adapter to an appropriate AC power source, and the
adapter cable into the Power Jack on the VM0202HB.
9. Power on all the connected devices.
RS-232 Protocol
Baud Rate
19200
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None
HDMI Display Devices
HDMI Source Devices
Hardware / Software
Controller
7
4
1
6
8
3
2
5
