ATEN CS1842, Руководство пользователя

Страница: 23 / 88

11
Chapter 2
Hardware Setup
Cable Connections
To set up your installation, refer to the installation diagram on the following
page (the numbers in the diagram on page 14 correspond to the steps below),
and do the following:
1. Ground the CS1842 / CS1844 by connecting one end of a grounding wire
to the grounding terminal and the other end to a suitable grounded object.
Note: Do not omit this step. Proper grounding helps to prevent damage to
the unit from power surges or static electricity.
2. Plug your USB keyboard and USB mouse into the USB console ports from
the console ports section located on the unit’s rear panel.
3. Plug your HDMI monitors into the HDMI console ports from the console
ports section located on the unit’s rear panel and power on the monitors.
1. Important safety information regarding the placement of this
device is provided on page 65. Please review it before
proceeding.
2. To prevent damage to your installation from power surges or
static electricity. It is important that all connected devices are
properly grounded.
3. Make sure that power to all the devices you will be installing has
been turned off. You must unplug the power cords of any
computers that have the Keyboard Power On function.
4. Please operate the device with caution when under high
environmental temperatures, as the surface of the device may
become overheated under such conditions. For instance, the
surface temperature of the device may reach 70
°C (158 °F) or
higher when the environmental temperature reaches close 50 °C
(122 °F).