Chapter 4. Firmware Upgrade
27
Firmware Upgrade Recovery
There are three conditions that call for firmware upgrade recovery:
When the unit’s firmware becomes corrupted for some reason and you
are unable to operate it.
When a firmware upgrade procedure is interrupted.
When a firmware upgrade procedure fails.
To perform a firmware upgrade recovery, do the following:
1. Power off the CL6700.
2. Connect the
Firmware Upgrade Cable
to its
Firmware Upgrade Port
.
3. Slide the
Firmware Upgrade Recovery Switch
to the
Recover
position.
4. Power the CL6700 back on and repeat the upgrade procedure.
5. After the CL6700 has been successfully upgraded, power it off, and slide
the
Firmware Upgrade Recovery Switch
back to the
Normal
position.
6. Power the CL6700 back on.
Exiting Firmware Upgrade Mode
To exit the Firmware Upgrade Mode, do the following:
1. Slide the
Firmware Upgrade Recovery Switch
(see page 6) to the
Normal
position.
2. Power off and restart the CL6700 according to the instructions given in the
Содержание CL6700
