Chapter 2. Hardware Setup
19
Setting Up the CE924
Setting up the CE924 USB DisplayPort Dual View HDBaseT 2.0 KVM
Extender system is simply a matter of plugging in the cables. Make sure that
all the equipment to be connected are powered off. Refer to the installation
diagram on the following page and do the following:
1. Make sure the CE924 units are properly grounded.
Note:
Do not omit this step. Proper grounding helps to prevent damage to
the unit from power surges or static electricity.
2. Connect the audio connectors of the supplied pink and green audio jack
cable sets to the audio ports located on the CE924L’s rear panel. Connect
the other end of the cables into the microphone/speaker ports on the local
computer.
3. Connect the USB connector of the supplied USB Type-A to USB Type-B
cable to the USB Type-B port on the CE924L’s front panel. Connect the
other end of the cable into a USB Type-A port on the local computer.
4. Connect both DisplayPort connectors of the supplied DisplayPort cables to
the DisplayPort input ports located on the CE924L’s front panel. Connect
the other end of the cables into the DisplayPort ports on the local
computer.
5. Connect one end of a Cat 5e/6/6a cable into the HDBaseT output port on
the CE924L’s rear panel. Connect the other end of the Cat 5e/6/6a cable
into the HDBaseT input port on the CE924R’s rear panel.
Note:
We recommend to adopt ATEN 2L-2910 Cat 6 cable for HDBaseT
connection.
6. Use two DisplayPort cables to connect the DisplayPort output ports
located on the CE924R’s front panel to your monitors.
7. Connect the USB connectors from the USB devices (mouse, keyboard,
etc.) into their respective USB Type-A ports located on the CE924R’s rear
panel.
8. Connect the audio connectors from the microphone and speakers into their
respective audio ports on the CE924R’s rear panel.
9. (a) Plug one of the supplied power adapter into a power source; then plug
the adapter’s power cable into the power jack located on the CE924L’s rear
panel.
