ATEN ALTUSEN PN0108, Руководство пользователя

Страница: 13 / 92

Chapter 1. Introduction
3
Features
Š
Remote power on/off/reboot control for eight outlets via TCP/IP and a
built in RS-232 PON (Power over the Net™) port
Š
Local power on/off/reboot control via the PN0108's PON port to the
computer's RS-232 port
Š
Daisy chain up to 15 additional stations to control up to 128 outlets
Š
Manual switching between Local and Remote access for each port via
front panel push button switches
Š
Individual control of each port – users can set the power on sequence and
delay time for each port to allow equipment to be turned on in the proper
order
Š
Easy setup and operation via a GUI interface
Š
Provides three configuration/management methods: Browser; Telnet; or
Console Terminal
Š
Safe shutdown and rebooting for Windows systems*
Š
Overcurrent protection and recovery for each AC port (110 V model only);
total port overcurrent protection (both models) – remote users can monitor
the current status via the GUI interface
Š
Separate circuits for the unit's power and the power to the devices – the
power control status menu is still accessible even when an overcurrent
condition trips the devices' circuit breaker
Š
On/Off scheduling – allows everything from a one-time start/shutdown, to
daily, weekly, etc. starts/shutdowns at user-specified times
Š
Port grouping – perform the same action on a specified group of ports
Š
LEDs for easy status monitoring
Š
Two level (Administrator and User) security
Š
Configuration can be reset
Š
Firmware upgradeable – daisy chained stations receive the upgrade via the
daisy chain bus
* Safe shutdown and rebooting is supported if the Power Monitor utility has
been installed (see Automated Setup , page 48).
pn0108.book Page 3 Friday, December 14, 2007 4:15 PM