B. Game Inspection
C. Game Installation
Asteroids
This new game is ready to play upon removal from
the shipping carton. However, your careful inspec
tion is needed to supply the final touch of quality
control. Please follow these steps to help us insure
that your new game was delivered to you in good
condition.
NOTE
Do not plug the game in yet!
Figure 2 Installation Requirements
Power
Temperature
Humidity
Space Required
Game Height
175 watts
O to 38° C (32 to 100°F)
Not over 95% relative
65 x 79 cm (251/2 x 31 in.)
184 cm (721/2 in.)
1.
Examine the exterior of the game cabinet for
dents, chips, or broken parts.
2.
Unlock and open the access panel of the
cabinet and inspect the interior of the game as
follows:
a. Check that all plug-in connectors (on the
game harness) are firmly seated. Replug
any connectors found unplugged. DON’T
FORCE CONNECTORS TOGETHER. The
connectors are keyed so they only go on in
the proper orientation. A reversed edge
connector will damage a PCB.
b. Check that all plug-in integrated circuits
on the game PCB are firmly seated in their
sockets.
A WARNING
To avoid possible unpleasant electrical
shock, do not touch internal parts of the
TV monitor with your hands or metal ob
jects held in your hands!
1. Voltage Selection
Before plugging in your game, make sure that the
voltage selection plug on the power supply (see
Figure 3) is correct for your location’s line voltage.
Check the wire color on the plug and see if it is cor
rect per the list below.
Line Voltage Range
Voltage Selection Plug Color
90-110 VAC (100)
Violet
105-135 VAC (120)
Yellow
200-240 VAC (220)
Blue
220-260 VAC (240)
Brown
2. Interlock and Power On/Off
Switches
c. Note the location of the game’s serial
number— it is on the metallic label on the
back of the game cabinet. Verify that the
serial numbers also stamped on the Game
PCB, Regulator/Audio PCB and TV Monitor
are all identical. A drawing of the serial
number locations is on the inside front
cover of this manual. Please mention this
number whenever you call your distributor
for service.
d. Check all major subassemblies such as the
power supply, control panel and TV monitor
for secure mounting.
To minimize the hazard of electrical shock while
working on the inside of the game cabinet, two inter
lock switches have been installed (see Figure 4).
One is located behind the access panel and one is
behind the coin door. These switches remove all AC
line power from the game circuitry when a door is
opened.
Check for proper operation of the interlock
switches by performing the following steps:
1. Unlock and open the access panel and the coin
door.
2.
Plug the AC line power cord into an AC outlet.
3. Close the access panel and coin door.
3
Содержание ASTEROIDS
