BEU SYSTEM PRACTICES
AT
&
TCo Standard
SECTION 503-400-200
Issue 1, September 1980
5011T01A "TOUCH-A-MATIC®" S SERIES TELEPHONE SET
IDENTIFICATION, INSTALLATION, CONNECTIONS, OPERATION,
AND MAINTENANCE
1.
GENERAL
1.01
This section contains information on the
TOUCH-A-MA TIC S series I2-button, wall
type telephone set (Fig. I and 2).
1.02
Whenever this section is reissued, the reason(s)
for reissue will be listed in this paragraph.
1.03
This telephone set can only be used on
individual or single line TOUCH-TONE®
service.
Note:
This set is not designed for speakerphone,
loudspeaker,
A
lead control, or party line
service.
1.04
The set is available in the colors listed Table
A. The only faceplate color available for
the automatic dialer is silver (-I22).
2.
IDENTIFICATION
2.01
The 5011TOIA wall telephone set has a
•
Capability to record, change, or delete
numbers in memory
•
Single button dialing and directory space
for names and telephone numbers
•
Two illuminated buttons to highlight important
telephone numbers
•
MIA handset
•
Electronic tone ringer
•
Internal SI sounder unit which provides
tones for automatic dialing, indicating proper
recording procedures, and for checking the
battery
•
Battery powered repertory dialer
•
Telephone number recording with handset
on- or off-hook. Off-hook recording does
not interfere with conversation
•
RECORD ON/OFF button protected during
normal usage by faceplate to prevent
inadverent erasure of stored numbers
•
Built in polarity guard.
I2-button automatic dialing feature.
The
two top name and digit buttons are illuminated
by red and green light emitting diodes (LEDs).
The set also contains a TOUCH-TONE dial, tone
ringer, and a MIA handset.
2.03
Operating Features:
2.02
Design Features:
•
Modular unit
•
Solid state circuit memory and network
•
Automatic dialing of up to I2 preprogramed
telephone numbers
•
Will store up to I6 digits per number
NOTICE
This set is not compatible with all
facilities due to limited available loop
current, and may not function properly
in all cases.
When these sets are
connected to these facilities, such
as analog loop carrier systems
(SLC-1 type, SLC-8 type) and
long loops (over 1300 ohms), the
sets may not dial from the manual
Not for use or disclosure outside the
Bell System except under written agreement
Printed in U.S.A.
Page 1
BSP 503-400-200-iOl 1980-09-Ql.jpg Scanned by Frank Harrell, {Cowboy Frank)
Castle Rock, Colorado Feb 08, 2012 22:03:53
