AT&T OneVision DEFINITY G3 Guide, Инструкция по установке и подключению, Страница: 50 / 287

3-10 Issue 2 April 1996
UnixWare Installation
To Set System and Node Names
To Set System and Node
Names
Introduction Before the Proxy Agent can interact with your network properly:
■
The system and node names must match.
■
The system name that is on the PA001 form must match the
system name that is on your network.
Definitions
■
The system name is the name of your Proxy Agent.
■
The node name is the name of your Proxy Agent PC as it is
known to the TCP/IP network.
When to use You set your system and node names after you have installed
UnixWare.
Materials
needed To set the system and node names, you need the name of your
system as it is printed on the PA001 form.
UNIX
options
The following table describes the UNIX options that are used with
the uname command to compare system names.
Option Description
-n Node name
-s System name