AT&T OneVision DEFINITY G3 Fault Management and integration, Руководство пользователя

Страница: 116 / 153

Report Builder
7-6 Issue 2 April 1996
Table 7-3. Field Entry Area
Field Description
Report Name The name of the report. You can enter up to 55
characters, or you can select an existing report from the
pull-down list.
Table to Search The name of the table that you want to search. You must
select one of the following values from the pull-down list:
■
Alarms (default)
■
Circuit Packs
■
DS1 Circuit Pacts
■
Errors
Field Name The name of the field in the database that you want to
match. Valid values are:
■
Blank
■
Any name on the pull-down list
The names on the pull-down list vary depending on your
selection in the Table to Search field.
You can select up to three Field Names for each report.
Comparison Indicates the type of comparison between the value(s) in
the Field Name field and the corresponding value field(s).
Valid values that you can select from the pull-down list
are:
■
Equal (default)
■
Range
Value One of the following:
■
If you set the Comparison field to Equal, then Fault
Management retrieves all values that match the value
in this field.
■
If you set the Comparison field to Range, then Fault
Management retrieves all data that fall in the range
created by this entry and the entry in the To Value
field.
■
If you set the Comparison field to Range, and if you
leave the To Value field blank, Fault Management
retrieves all data equal to or greater than the entry in
this field.