AT&T MERLIN LEGEND Release 3.1, Руководство по системному программированию

Страница: 521 / 887

PRI Facilities
Programming Procedures
4–149
Console Display/Instructions Additional Information PC
2 Save your entry.
Select
Enter Enter
.
0
3 Erase the current telephone number (
n
).
Line xxx:
xxx = line entered in Step 1
Enter phone number to
send on outgoing calls
N
Backspace Next
Exit Enter
Press Drop .
A
+
P
4 Enter a telephone number of up to 12 digits to send
(
N = any combination of 0 to 9).
Dial or type [ N ].
Û
5 Continue to assign the telephone number to another line or go to Step 6.
Select
Next Next
.
9
Return to Step 3. The next line will be
displayed on Line 1.
6 Save your entry.
Select
Enter Enter
.
0
7 Return to the System Programming menu.
Select
Exit Exit
two times.
55
Test Telephone Number
Use this procedure to assign a test line or trunk telephone number for each
100D module installed in the control unit.
The number assigned to the test line/trunk must be different from the numbers
assigned to other channels in the same B-channel group. It must be the same
number as that provided by the PRI service provider.
Summary: Test Telephone Number
Programmable by System manager
Mode Hybrid/PBX, Key
Idle Condition Not required
Planning Form Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
Factory Setting Not applicable
Valid Entries Telephone number of up to 12 digits