AT&T MERLIN LEGEND Release 3.1, Руководство по системному программированию

Страница: 474 / 887

Tie Trunks
4–102
Programming Procedures
Console Display/Instructions Additional Information PC
4 Enter a tie trunk number.
E&M Signal:
Enter trunk for assignmt
Dial or type:
Û
Trunk number [ nnn ]
Backspace
Slot and port number
*
[ sspp ]
Exit Enter
Logical ID number
#
[
nnn
].
5 Save your entry.
Select
Enter
Enter
.
0
6 Specify the type of signaling for the trunk.
Trunk xxx:
xxx
= trunk entered in Step 4
Select E&M Trk Signaling
_
Type1S
_
Type1C
_
Type5
Select
Type1S Type1S
,
1
Next Type1C Type1C
, or
2
Exit Enter Type5 Type5
.
3
7 Continue to assign E&M signaling to another trunk or go to Step 8.
Select
Next Next
.
9
Return to Step 6. The next trunk will be
displayed on Line 1.
8 Save your entry.
Select
Enter Enter
.
0
9 Return to the System Programming menu.
Select
Exit Exit
two times.
55
Dial Mode
Use this procedure to specify whether an incoming or outgoing tie trunk is touch-
tone or rotary.
Touch-tone cannot be programmed for incoming immediate signaling tie trunks.
Users of touch-tone single-line telephone users cannot make calls by using
individual trunks programmed for rotary operation. The touch-tone signals
generated from the telephone while dialing are transmitted to the central office at
the same time the rotary signals are sent to the system. The central office
receives both signals and cannot process the call.