AT&T MERLIN LEGEND Release 3.1, Руководство по системному программированию

Страница: 423 / 887

Lines and Trunks
Programming Procedures
4–51
Console Display/Instructions Additional Information PC
3 Assign or remove the line/trunk from the specified QCC operator.
Select
Enter Enter
or
0
Delete
Delete
.
8
You may continue to assign or remove
additional lines/trunks from the QCC
operator by repeating Steps 2 and 3.
4 Continue to assign line/trunk to another QCC operator or go to Step 5.
Select
Next Next
.
9
Return to Step 2. The next QCC operator
will be displayed on Line 1.
5 Return to the System Programming menu.
Select
Exit Exit
two times.
55
◆
Block Procedure
1 Specify the block of 20 lines associated with the 20 line buttons on the system
programming console.
Select
Lines 01-20 Lines 01-20
1
Lines 21-40 Lines 21-40
2
Lines 41-60 Lines 41-60
3
Lines 61-80 Lines 61-80
.
4
2 Assign or remove the lines for the specified QCC operator.
Toggle the green LED on or
off as required.
On = operator receiving calls.
Off = operator not receiving calls.
3 Return to the System Programming menu.
Select
Exit
Exit
two times.
55
Loop-Start Identification Delay
Use this procedure to delay the alerting (ringing) of calls arriving on loop-start
lines/trunks connected to an 800 GS/LS-ID module to all extensions until
approximately six seconds have elapsed since the port module informed the
system software that the line was ringing, or the system software has been
informed that Caller ID information is available, whichever comes first.
This option can be programmed on a per trunk basis. It gives the appearance to
the users that the Caller-ID information is available the moment the call arrives at
the extension, and prevents applications or adjuncts from answering the call too
soon.