The cable must be configured as shown in Table 3-2.
TABLE 3-2 Pinout Assignment for the TI 700 Printer
MERLIN II Attendant
TI 700 Printer
Signal Ground—3
7/5—Signal Ground
Data Terminal
Ready-8
6/6-Data Set Ready
Data Set Ready-6
20/4—Data Terminal Ready
4/7—Request to Send
5/8-Clear to Send
Transmit Data—4
3/2—Receive Data
Receive Data-2
2/3—Transmit Data
Once the cable is configured and the printer is connected,
perform the following steps:
N O T E :
If any of the report counters exceed 65,535 total,
the counter is reset to 0.
Printing Call Handling
To
print a report, perform the following steps:
R e p o r t s
1
Dial the
MERLIN II Attendant extension from a
Touch-Tone phone, preferably a single-line set.
2
Wait for an answer.
3
Dial * followed immediately by the authorized
caller
code and #.
4
Dial
*2909 and the following appropriate choice:
I
=
print route programming
2
=
print traffic analysis report
3
=
print business schedule
4
=
print announcement time allocations
5
Once the report is complete, exit authorized caller
mode by dialing *#.
6
T o
d i s c o n n e c t , d i a l # .
Troubleshooting 3 - 7
Содержание MERLIN II Attendant
Страница 1: ...AT T MERLIN II COMMUNICATIONS SYSTEM MERLIN II Attendant Installer s Guide...
Страница 21: ...FIGURE 1 4 Connecting the MERLIN II Attendant Connecting the MERLIN II Attendant 1 17...
Страница 33: ...FIGURE 2 2 Supervised Transfer process 2 12 Programming Features...
Страница 35: ...FIGURE 2 3 Immediate and Backup Call Handling 2 14 Programming Features...
