AT&T MERLIN II Attendant, Руководство по установке

Страница: 27 / 53

REALLOCATING
ANNOUNCEMENT
TIMES
3
Continue programming or dial *# to exit authorized
caller mode.
4
To disconnect, dial #.
Five announcements are available. Each has a default
duration in seconds, totaling 64 seconds. Refer to
MERLIN II Attendant Planning Form D to see if the
customer has elected to lengthen or shorten any of the
time allocations. If a customer is not using an
announcement, set the allocated time to 00. The default
allocations are as follows:
TABLE 2-1 Default Announcement Time Allocations
Seconds Announcement
20 Day
announcement
2 0 N i g h t a n n o u n c e m e n t
14 Transfer Fail announcement
5 Hold announcement
5
Connect announcement
N O T E :
If the time allocated to one announcement is
increased, decrease another time accordingly so
that the total time does not exceed 64 seconds.
Announcements are recorded only up to the time
allocated. If while recording an announcement
you run over the time allowed, the recording
stops at the time allocated. Therefore, always
play back the announcements to be sure they
were completely recorded. See “Playing Back
Announcements” in this section.
2-6 Programming Features