AT&T Merlin 1030, Руководство администратора

Страница: 107 / 191

SETTING THE RECALL TIMER
With the MERLIN system, you touch Recall instead of using the switchhook flash
(a brief press of the switchhook). Your MERLIN system is factory-set to keep the out-
side line open for 450 milliseconds when you touch Recall. You can make this inter-
val shorter or longer if you encounter these situations in your business:
• If people press Recall and nothing happens, the interval is too short. Change
it to 650 milliseconds.
• If people press Recall and the outside call is disconnected, the interval is too
long. Change it to 350 milliseconds.
NOTE: The Recall button cannot be used with outside calls if your system has
Automatic Route Selection.
Follow the procedure below to change the Recall interval.
1. If you haven't done so already, enter administration mode by following the boxed
instructions on page 28.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing and the green
light next to Adm Misc becomes steady.
3. Dial the approriate 5-character code for the time interval you prefer:
• #3180 for 350 milliseconds
• #3181 for 450 milliseconds
• #3182 for 650 milliseconds
• # 3 1 8 3 f o r 1 s e c o n d
4. If you have a printer, you can verify that the delay is set correctly by checking your
System Information Report. To get a printout, dial the 4-character code #905.
The green light next to Adm Misc flashes. When the printout is completed, you hear
a b e e p a n d t h e g r e e n l i g h t n e x t to A d m M i s c b e c o m e s s t e a d y .
Don't go on to step 5 until you hear the beep or you'll get an incomplete printout. Wait to
remove your printout until you've completed step 5 or your page alignments will be affected
5. Touch Adm Misc.
The lights next to the administration button flash.
6. Continue to administer your system or leave administration mode by following
the boxed instructions on page 28
104