Installing a Single Carrier on a Wall
■
■
■
Install high on wall, leaving at least 6 inches (15.2 cm) between antennas and
ceiling
Never install or remove a radio module from a carrier that is plugged into a wall
outlet (hot insertion)
See “Key Components” earlier in this chapter for additional picture detail
1
Check to make sure the carrier’s power cord is
unplugged from the wall outlet before continuing.
Place the carrier against the wall. Choose a loca-
tion backed by a wooden stud (if unavailable, use
2
toggle bolts instead
-
of the supplied wood screws). Hold
the carrier straight; use a level if needed. Using a nail or
pencil, mark screw locations through the four wall mount
holes.
Start the screws, leaving the screw heads approxi-
mately ½” (12 mm) from the wall. Place the carrier as-
sembly over the screws, then slide it downward to lock it
into place. Tighten the screws.
3
Remove the plastic cap covering each radio
module’s card edge before inserting the radio
modules into the carrier.
4
Starting from the leftmost slot (#1), insert each
radio module into the carrier by hooking it onto
the radio module mounting rod. Slowly swing the radio
module’s card edge into the card edge connector on
the back of the carrier.
Installing the MDW 9010
2-17
