32
Appendix
This telephone is set up to comply with the energy-conserving standards right out of the box.
These instructions are intended for California Energy Commission (CEC) compliance testing
only. When the CEC battery charging testing mode is activated, all telephone functions, except
battery charging, will be disabled.
When first purchased and properly installed for charging (see
Battery installation and
charging
on pages 7- 9), put the handset in the handset charger to charge. The CEC
battery charging testing mode is activated while charging.
If you have registered the handset to the
CL82219/CL82229/CL82319/CL82419/CL83519
base, below are the testing instructions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are inserted with charged batteries before proceeding.
2. While you press and hold
/FIND HS
, plug the telephone base power adapter back to
the power outlet.
3. After about 20 seconds, when the
IN USE
light starts flashing, release
/FIND HS
,
and
then press it again within two seconds.
When the phone successfully enters the CEC battery charging testing mode,
the
IN USE
light turns off and all handsets display
To register HS, see manual
.
When the phone fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 10-11 for handset
registration instructions.
California Energy Commission battery charging
testing instructions
BC
