between failing test
Yes
Subroutine
Phase
DETERMINE LOCATION AND FUNCTION OF DOLOOPS, SUBROUTINES CALLED
[5] Is
referenced
[6] Are any
endloop references
[7] Was this
subroutine called
from phase or from
another subroutine
No
Yes
No
subroutine
and end of
endloop MACRO
Locate failing test in last subroutine called. Look past
failing test for endloop statements. For each endloop
statements. Locate each doloop statement. Obtain doloop
index values from raw data printout and determine their
statement located in subroutine, use endloop label
variable to identify location of associated doloop
subroutine was called and look for endloop statements after
data printout for first failing test are located. Read any
after
CALLSUB
statements until all doloops indicated on raw
comments at doloop statements.
AND
statement was not found in subroutine, go where
CALLSUB
statement. Continue looking for endloop statements
SUMMARY
statement definitions
as necessary
[2] Locate failing test in
last subroutine called
and note page and line
number of expected
results (EXPR)
[3] Locate last address in
this subroutine and note
reference section
page and line number
[4] Locate subroutine PIDENT
in Section 234-180-020
DIAL
meaning for each doloop [Figure 1, Page 2]. If endloop
[1] Refer to Figure 1,
504
DLP
PAGE 1 of 6
234-151-013
DEC 1995
Issue 8
