Atag WS90211MX, Инструкция по эксплуатации

Страница: 100 / 112

Safety regulations
WARNING!
This appliance should only be connected by a registered installer.
• Always follow the installation instructions in the installation manual
provided.
• Check the appliance for transport damage. Do not connect a
damaged appliance.
• Faulty parts may only be replaced by original parts.
The manufacturer can only guarantee that original parts meet
safety requirements.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
• Always use the original Supply cord to connect the appliance.
• The electrical connection must comply with national and local
regulations.
• The wall plug socket and plug should always be accessible.
• If a stationary appliance is not fitted with a supply cord and a
plug, or with other means for disconnection from the supply mains
having a contact separation in all poles that provide full
disconnection under overvoltage category III conditions, the
means for disconnection must be incorporated in the fixed wiring
in accordance with the wiring rules. This is also applicable for
appliances with a supply cord and plug when the plug is not
accessible after installing the appliance. Using an omnipolar
switch with a contact separation of at least 3 mm fitted in the fixed
wiring will fulfil this requirement.
• The appliance should not be connected to the mains via a
multi-plug adapter or extension cable, as the safe use of the
equipment cannot be guaranteed.
16
Installation