GB 13
fitting the telescopic pipe
NB
: During recirculation (WG8), the ventilation slits must not
be covered by the lower telescopic pipe.
Slide the flanged end of the upper telescopic pipe upwards
between the fixing bracket and the wall, and slide the
telescopic pipe against the ceiling. The telescopic pipe locks
into position.
Hook the lower telescopic pipe onto the upper telescopic
pipe and allow it to drop.
Put the filters in place and test the extractor hood.
assembly
(continued)
GB 12
assembly
(continued)
Suspend the motor module on the threaded ends (1). Screw
the nuts on. Make sure that the motor module is exactly level.
Drill holes (2 x ø 6 mm) and secure the motor module with the
fixing pins supplied (6 x 60) (2).
Fit the discharge duct.
Connect the motor module electrically.
fitting the hood
Fit the hood to the motor module.
First hook the rear of the hood into the motor module at the
bottom (1).
Then lift the front up (2) so that the two bolts supplied (M5 x
12) can be screwed in (3). Use these bolts to level the hood.
Make the plug connections in the hood.
1
1
2
2
3
