2-26
Chapter 2: Hardware information
Chapter 2
2.8.3
Internal connectors
Drive jumper setting
Mode of device(s)
Cable connector
Single device
Cable-Select or Master
-
Black
Two devices
Cable-Select
Master
Black
Slave
Gray
Master
Master
Black or gray
Slave
Slave
•
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select”, ensure that all other device jumpers have the
same setting.
1.
IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are
three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard’s IDE connector, then select one of the
following modes to configure your device.
M5A88-V EVO
PRI_EIDE
NOTE:
Orient the red markings
on the IDE ribbon cable to PIN 1.
PIN1
M5A88-V EVO IDE connector
Содержание M5A88-V EVO
Страница 1: ...Motherboard M5A88 V EVO ...
Страница 14: ...xiv ...
Страница 56: ...2 38 Chapter 2 Hardware information Chapter 2 ...
Страница 96: ...3 40 Chapter 3 BIOS setup Chapter 3 ...