English
28
All-in-one PC ET2011 Series
Positioning your All-in-one PC
Placing on the desktop
Place your All-in-one PC on a flat surface such as a table or desk, and pull the stand open until
pull the stand open until
it snaps in place. Then, tilt the display panel to an angle of between 12 and 27 degrees from an
upright position.
12
O
0
O
27
O
0
O
Mounting to the wall (optional)
To mount your All-in-one PC to the wall, purchase the optional wall mount kit (VESA 75, 75mm
x 75mm or VESA100, 100mm x 100mm). Install the wall mount kit according to the following
instructions.
1. Place your All-in-one PC on a flat surface
such as a table or desk, and then remove
the two screws beside the stand. Keep the
screws for future use in case you want to
reinstall the stand.
