ASUS ESC2000 G2
5-3
5.1.2
Installing Serial ATA hard disks
The system supports Serial ATA hard disk drives. For optimal performance, install identical
drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID configuration:
1.
Install the SATA hard disks into the drive bays.
2.
Connect the SATA signal cables.
3.
Connect a SATA power cable to the power connector on each drive.
5.1.3
Setting the RAID item in BIOS
You must enable the RAID function in the BIOS Setup before creating RAID set(s) using
SATA HDDs. To do this:
1.
Enter the BIOS Setup during POST.
2.
Go to the
Advanced
menu >
SATA Configuration
, and then press <Enter>.
3.
Set the
SATA Mode
item to [RAID Mode].
4.
Save your changes, and then exit the BIOS Setup.
Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.
Due to chipset limitation, when set any of SATA ports to RAID mode, all SATA ports run at
RAID mode together.
Содержание ESC2000
