7
LOW TEMPERATURE MODE (QS-4U)
In Low Temperature (Sentinel) mode, system starts your engine
automatically when temperature falls below a preset level (programmable
during installation), see table. Factory default setting is shaded.
Engine will run for programmed runtime, after which system will wait 2½
hours and then start engine again if temperature is still below preset level.
Factory default setting is shaded.
To activate/deactivate Low Temperature mode, press
and
buttons simultaneously.
W
HEN MODE IS ACTIVATED
:
Parking lights will flash 4 times, then, if temperature is below preset level, engine will start.
If temperature is above preset level, system waits until it goes below preset level before starting.
In the case of a manual transmission vehicle, the system must have detected a valid security sequence to allow the
activation of Low Temperature mode. (see “Safety sequence for manual transmission vehicles” on page 3).
If system cannot execute command (for example, hood is open), confirmation will be different (lights: 3).
W
HEN MODE IS DEACTIVATED
:
Parking lights will flash twice to confirm that mode is deactivated.
Applying brakes also deactivates Low Temperature mode.
LOCK/UNLOCK COMMANDS
(QS-4U)
If your vehicle is equipped with electric door locks, several functions can be operated by remote control.
These features are optional and may require purchasing additional equipment. Consult your dealer for advice.
Following systems can be controlled:
•
Door locks.
•
Trunk or hatchback release.
•
Interior lights.
LOCK
Press the
button, doors are locked and parking lights flash once to confirm command has been received.
Parking light confirmation is sent as many times as command is repeated so you are sure that system has received the
command. Horn sounds once if option "Confirmation on 2nd lock" was set (during installation).
UNLOCK
Press the
button, doors are unlocked and parking light flashes twice to confirm command has been received.
The “Unlock“ function can be programmed and connected in such a way that the first Unlock command only unlocks the
driver's door, while a following Unlock command unlocks the other door(s).
Dome light will turn on for 30 seconds every time (optional connection during installation)
•
unlock command is sent;
•
engine is stopped (ignition switch);
•
continuous mode is activated.
This 30-second duration is cancelled when Lock command or Trunk command is sent, brakes are applied or key is inserted
in ignition and turned to RUN position.
Threshold temperature is set for
-5 °C ( 23 °F)
-20 °C ( -7 °F)
-15 °C ( 5 °F)
-30 °C ( -22 °F)
Engine runtime (Low temp mode) is set to
2 minutes
8 minutes
4 minutes
18 minutes
