TrojanTwo-Compact User Guide v3.8
Page | 78
13
Using the built in slitter for T2-C press
13.1
Purpose
The T2-C press has a built in in-line slitter that works perfectly with die cut label material. Slit up to four (4)
rolls, with the three (3) easy to replace oscillating blades that ensures long life time and perfect cuts. The
blades can placed in any position or moved to the side when not in use.
13.2
Usage
IMPORTANT:
The built in slitter blades can only be used with pre-diecut label material. Therefore the slitter
can only be enabled if TOF mode is set to diecut at TrojanTwo tab -> Media settings menu.
1.
Thread the diecut label roll throughout the web path of the T2-C press.
(See chapter 4 for loading the label roll)
2.
Load matching cardboard paper cores to the rewinder shaft according to how many rolls are to be
slit up (max. 4).
3.
Open the back lid all the way up on the T2-C press to gain access to slitter blades:
4.
Move the slitter blades manually to the position where you want to slit the rolls along the pre-
diecut lines on the label roll:
