TrojanTwo-Compact User Guide v3.8
Page | 12
3
Power On
3.1
Visible safety check
Before powering on the machine, visibly ensure that no foreign objects are interfering with the print
engine module and web-path.
3.2
Power on process
1.
Press the physical power switch on the left side of the T2-C press, switching it from 0 to 1.
Turning the main power switch on starts up the TrojanControl software on touch screen and also
starts up the print engine.
2.
Release the Emergency Stop (ER) button in case it is pressed down. To release the ER button, the
button has to be twisted clockwise. As long as the ER button is pressed down, the servo motors for
the Unwinder, Rewinder and NIP are powered off for safety reasons. It is advised to press the ER
button whenever the operator wants to perform any other actions on the web path system than
threading the label material or splicing and installing a new label roll.
Emergency Stop button on top of the T2-C press.
3.
The machine is fully functional, when the TrojanTwo tab is visible on the TrojanControl software
and at right side status bar the ‘system state’ field is online and ‘media path state’ is ready.
T2-C press is ready to print.
NOTE:
System state can only be online if all ink tanks are installed and printhead is also installed and
primed up with ink (see chapter 3.3 for installing the ink tanks and printhead).
Web state can only be ready if the label material is loaded to unwinder and rewinder and tension
for the label web is calibrated (see chapter 4 for loading the label material and calibrating tension
for the label web).
